Wiring a 2000 Camaro Power Mirror Switch to a Fiero with Power Mirrors

The Camaro switch controls both power mirrors from the drivers door. The Fiero has the switch in the center console. So first, move the Fiero switch wiring to the door. It is long enough to reach the door without lengthening. Cut the Fiero switch off so that the wires will fit through the door seal. Wire the Camaro switch to the Fiero wires as shown. Next, follow the wires from the switch up until they come to a “Y” in the dash / radio and vent area. This is where the single loom splits into two to go to each mirror. Stock, it will have both the yellows and blues joined together. Undo this, and wire as shown, joining the light blue and green / black wires together to the yellow wire (driver side loom), then the blue and green wires together to the light blue wire (passenger side loom).

CAMARO SWITCH

A – ORANGE = POWER (+)
B – YELLOW = DRIVER MIRROR: UP/DOWN MOTOR
C – LIGHT BLUE = DRIVER MIRROR: LEFT/RIGHT & UP/DOWN COMMON
D – WHITE = DRIVER MIRROR: LEFT/RIGHT MOTOR
E – RED / WHITE = PASSENGER MIRROR: LEFT/RIGHT MOTOR
F – GRAY = PASSENGER MIRROR: LEFT/RIGHT & UP/DOWN COMMON
G – BROWN / WHITE = PASSENGER MIRROR: UP/DOWN MOTOR
H – BLACK = GROUND (-)

FIERO SWITCH

A – ORANGE = POWER (+)
B – BLACK = GROUND (-)
C – YELLOW = BOTH DRIVER & PASSENGER MIRRORS: UP/DOWN MOTORS
D – LIGHT BLUE = BOTH DRIVER & PASSENGER MIRRORS: LEFT/RIGHT MOTORS
E – LIGHT GREEN / BLACK = DRIVER MIRROR: UP/DOWN MOTOR
F – WHITE / BLACK = DRIVER MIRROR: LEFT/RIGHT MOTOR
G – LIGHT GREEN = PASSENGER MIRROR: UP/DOWN MOTOR
H – WHITE = PASSENGER MIRROR: LEFT/RIGHT MOTOR