Cheetah found many years ago that first-generation Neon Strut Tower Braces are a
great fit for the Dodge Daytona
and similar vehicles. With the popularity of those Neon's, aftermarket parts
for them are very affordable.
The early K-based cars on the other hand, are sorely lacking in aftermarket
support. So with a few minutes
with a hand drill, take advantage of all of STB options for the Neon.
The length and size of the brace are perfect for the Daytona. One hole on
each side even lines up. But the
other two holes on each are in different places (although on the same bolt
circle).
Simple solution: drill the other two holes. If one is careful, one could
drill these by sight. But below
is a drawing to properly lay out the brace for drilling.
This following picture shows a Neon STB on our Daytona
If there are any other questions, feel free to ask.
Click to view our main Daytona page:
The information contained on these pages are the views of the
author, and constitute the author's opinion only.
Any damage or loss resulting from the use and / or misuse of the information and
/ or products here is the responsibility
of the reader and/or buyer. All items are sold as-is, and may be looked at on an
individual basis.
ALL RIGHTS RESERVED.